Product

The SMARTFinder is a handheld TDR fault locator with tone generator function. It can identify a specific pair of cable quickly. The LED display and simple menu is easy to read and understand the open short circuits, and indicate the fault distance. When clipping on to an unidentified pair at a job site, with voltage up to 250V AC, the unit will immediately sound an alarm. The SMARTFinder tone generator function is detectable with Hobbes probe for use in tracing and identification of pairs within a cable. Technicians can find and fix cable problems without pulling new wire or cutting into walls but saving time and cost.

• Indicating fault distance by TDR technique

• Tone generator function can be detectable with Hobbes probe

• It measures distance open or fault location from one end of cable

• High voltage detection

• Simple menu is easy to use

Model No.: 256011

Input protection: 250V RMS AC, continuous or intermittent

Impedance range: Auto-compensation within 25 to 330ohms. Cables with impedance outside this range may produce erratic or incorrect readings

Maximum length: Main unit will display

Maximum cable testing length: 2700 feet (900m)

Minimum length: No minimum length

Accuracy: 1m inaccuracy in 100m, 1 to 3m inaccuracy in 300m, 3% inaccuracy when distance is above 300m

High Voltage detection: AC voltage>5 to 15 volts RMS will trigger high voltage warning

Measurement rate: Maximum of four completes measurement/second, decreasing to 2 seconds per measurement. Based on cable size and uniformity

Tone injection: Approximately 1kHz at an amplitude of 80% battery voltage

Operating temp.: 0º to 55ºC

Storage temp.: 0º to 70ºC

Battery: AAA 1.5V X 4

Dimensions: 30mm thick, 78mm wide, 120mm tall

SMARTFinder
Copper Cable Fault Locator

The SMARTFinder - Copper Cable Fault Locator is a handheld TDR fault locator with tone generator function. It can identify a specific pair of cable quickly. The LED display and simple menu is easy to read and understand the open short circuits, and indicate the fault distance. When clipping on to an unidentified pair at a job site, with voltage up to 250V AC, the unit will immediately sound an alarm. The SMARTFinder - Copper Cable Fault Locator tone generator function is detectable with Hobbes probe - Network Cable Tester Tracker for use in tracing and identification of pairs within a cable. Technicians can find and fix cable problems without pulling new wire or cutting into walls but saving time and cost.